12v.org

Home The Engine The Cars Links Registry FAQ Maintenance Modifications
 
Features   |   Identification   |   Component Locations   |   How it Works


MMS-3xx Functional Wiring Diagram

Components


F60: Idle switch
G4: Crankshaft Position Sensor
G6: Fuel pump
G28: Engine Speed Sensor
G39: Oxygen sensor I
G40: Hall Sensor
G61: Knock sensor I
G62: Engine Coolant Temperature (ECT) sensor
G66: Knock sensor II
G69: Throttle valve potentiometer
G70: Mass Air Flow (MAF) sensor
G98: Exhaust Gas Recirculation (EGR) temperature sensor
G108: Oxygen sensor II
J176: Fuel pump relay
J192: Engine Control Module (ECM)
N: Ignition coil for cylinders 1 and 6
N18: EGR frequency valve
N30: Fuel injector, cylinder 1
N31: Fuel injector, cylinder 2
N32: Fuel injector, cylinder 3
N33: Fuel injector, cylinder 4
N71: Idle Air Control (IAC) valve
N80: EVAP carbon canister frequency valve
N83: Fuel injector, cylinder 5
N84: Fuel injector, cylinder 6
N122: Power stage for ignition coils
N128: Ignition coil for cylinders 2 and 4
N156: Intake manifold change-over valve
N158: Ignition coil for cylinders 3 and 5
P: Spark plug connector (6x)
Q: Spark plug (6x)
S17: Fuse for G6
S19: Fuse for diagnostic connector
S64: Circuit breaker for N158, N128, and N
S72: Circuit breaker for N30, N31, N32, N33, N83, and N84
S73: Circuit breaker for G39, G108, N18, N80, and N156
S74: Circuit breaker for G70 and G74

Additional Signals


B8: Throttle valve signal (not pictured)
B9: Road speed signal (not pictured)
B10: Engine speed signal (not pictured)
B11: Fuel consumption signal (not pictured)
B12: Shift lever position signal (not pictured)
B13: Shift point signal (not pictured)
C10: A/C compressor signal (not pictured)
C12: Diagnostic signal for Rapid Data (K circuit)
C13: Diagnostic signal for Rapid Data (L circuit)
C14: Flash code signal 		 
Reference Sensor G4
64
The reference sensor is an inductive pickup. The sensor is located on the left-hand side of the engine block. The sensor is used to identify TDC of the number three cylinder.

A notch, 62° before TDC in the counterweight of the crankshaft for the number three cylinder, is used as the reference point. The notch, along with the reference sensor, generates one signal per crankshaft revolution.

The signal from the reference sensor along with the signal from the Hall Sensor (G40) are used during starting to identify the TDC third cylinder ignition point.
G4
Substitute Function

No substitute function for the reference sensor is available.

Self-diagnosis

The ECU recognizes a missing signal after five seconds of cranking or engine operation.

If this signal is not received by the ECU, the engine will not start.
 
 
 
Disclaimer
 
Back  
Home
Top